Quadro Comil® Overdriven

The Overdriven Comil is used for a wide range of products and applications. It can be found in thousands of factories all over the world, mixing and dispersing, size reducing, separating and reclaiming, and bulk density adjustment.

The typical particle size distribution (PSD) is tightly contained with the 125 micron to 1000 micron range (120 mesh to 18 mesh), depending on the screen and impeller choices. Traditional milling technologies do not have the same control over the PSD resulting in more fines and a flatter curve and less control over quality and repeatability.

Benefits & Highlights:

• Low speed design allowing for inherently gentle action on the product resulting in
• Optimum particle granularity
• Low heat
• Low noise
• Minimal fines
• Consistant, high-quality end product
• Can be used on heat sensitive products
• High capacities
• Can be flood fed
• Fully customizable to many different applications and process streams

Typical Applications:

• Granulation of dry powders for
• tablet manufacture
• solubles
• bulk density fine tuning
• sizing
• Size reducing and milling of wet or soaked products to produce liquid with wet suspended particulates
• Powders into pastes
• Wet blending
• Uniform sizing of wet granulation in tablet manufacturing
• Lump-free homogeneous blending to precise size requirements
• Reducing difficult, sticky, heat-sensitive agglomerates into pieces, crumbs or powders of uniform size, continuously without excessive heat buildup or screen blockage
• Reclaiming products from cream filled products to hard, compacted products

Available Models: